Racquetball Court to Squash Court Conversion
Moveable Walls
Designed for existing racquetball courts, the wall rests on custom-made urethane casters specially designed to roll easily over court surfaces. The wall is supported in the vertical position while in motion by expanding steel arms with torsion bars, eliminating the need for tracks in the side walls. This unique feature reduces installation costs and retains the integrity of the playing surface or floor.
Moveable Wall Example
Permanent Conversion from Racquetball Courts to Squash Courts
Anderson Courts at low cost can convert racquetball courts to squash by supplying and installing a permanent half inch tempered glass wall system (20' wide x 7" height) at the 32' length.
Anderson Courts crew will:
- Sand and re-stripe floor to conform to International squash standard
- Install Anderson Courts powder coated 16 gauge metal telltale to headwall
- Stripe headwall and sidewalls to mark out of bounds lines
Lawrenceville School Glass Walls
Materials and Specifications
- Glass is 1/2" clear floated tempered with exposed edges polished and conforming to federal specifications, ANSI-Z97.1; CPSC 16 CFR 1201; ASTM C1048
- All hardware for glass to glass connections is Hi-Tensile white and clear material with tensile strength minimum of 9,000 PSI and a durometer hardness of D80-90. (black nylon is also available). Metal fittings mounted on glass are not acceptable.
- Doors are 7'0" tall with 2 hinges (middle hinge not acceptable). Ellis Pearson hinges return to adjacent fin or post. (side hinging to adjacent glass only is not acceptable)
- Doors to be latched with knob set on exterior and flush pull ring on interior (positive latching system). Latch housing to be white powder coated finish. Strike and door stops to be fastened to adjacent glass or post. Key locking latches and latch keeps are also available.
- Perimeter channels - clear anodized aluminum
- Fin brackets are aluminum. Flush mount clear anodized aluminum cover plates are also available.
- Joint sealant - G.E. clear or equal
- Glass marking - Rear wall to have permanent etched white lines (1/8" wide, 24" high, 1" center). Side wall glass to have single dot pattern applied in color specified by architect or client.
The Maryland Club Glass Walls